羅茨風機的使用的用途蠻多的，一般用在工地或者工廠地方比較多，如何保養好羅茨風機的使用壽命，多久換一次潤滑油比較合適呢？下面小編帶大家分析一下？

Roots blowers are used for many purposes, usually on construction sites or factories. How to maintain the service life of Roots blowers and how often to change lubricating oil? Now let's take you to analyze?

其實正常來說在羅茨風機運行200小時左右，要一次換換油和脂，運行一個月二次更換油和脂。以后按使用環境及油(脂)質量狀況更換，建議按三個月更換一次為宜；油溫超過50度時。建議按一個月更換一次為宜。并可換用CKC--N320中負荷工業齒輪油。 羅茨風機投入運行后，小編建議運行8小時后更換全部潤滑油。 其中會有什么注意事項呢？ 一步掉齒輪油，隨之注入新的齒輪油。一次：開始運轉一個月后，三個月后二次更換，長期運行每半年更換一次。平時注意關注油位，及時補充。

In fact, it is normal to change the oil and grease once when Roots blower runs for about 200 hours and twice a month. In the future, the oil (grease) shall be replaced according to the service environment and oil (grease) quality. It is recommended to replace it every three months; When the oil temperature exceeds 50 degrees. It is recommended to replace it once a month. CKC-N320 medium load industrial gear oil can also be used. After Roots blower is put into operation, it is recommended that all lubricating oil be replaced after 8 hours of operation. What should I pay attention to? Remove the gear oil in one step, and then inject new gear oil. One time: one month after operation, two times after three months, and once every six months for long-term operation. Pay attention to the oil level and replenish it in time.

2.羅茨風機潤滑油量評測：

2. Evaluation of lubricating oil quantity of Roots blower:

羅茨風機各機型的油量隨時都可以看到齒輪側油鏡，停機時可以在中線之間保持油面。機油水平低于中間位置時，應及時添加潤滑油。如果油位高于中間位置，則有可能發生油溫高、尾氣噴射、氣體漏油等。

The gear side oil mirror can be seen at any time for the oil volume of each type of Roots blower, and the oil level can be maintained between the centerline during shutdown. When the oil level is lower than the middle position, add lubricating oil in time. If the oil level is higher than the middle position, high oil temperature, tail gas injection, gas leakage, etc. may occur.

3.羅茨風機潤滑油儲存：

3. Storage of Roots blower lubricating oil:

注入齒輪油后，其余的齒輪油不能直接暴露在外，防止其他污染物進入桶內，造成油品的污物。其次，油類要遠離火源，放置消化設備。使用完畢后擰緊蓋子，保持油桶密封。新油與廢油分開放置，裝廢油的容器不能裝新油，以防止污染。

After the gear oil is injected, the rest of the gear oil shall not be directly exposed to the outside to prevent other pollutants from entering the barrel and causing oil contamination. Secondly, oil should be kept away from fire sources and digestive equipment should be placed. After use, tighten the cover and keep the oil drum sealed. The new oil and waste oil shall be placed separately, and the container containing waste oil shall not be filled with new oil to prevent pollution.

以上就是為大家介紹的有關山東羅茨風機的詳細的介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以的態度,為您提供服http://www.rohs-international.com/

The above is a detailed introduction to Shandong Roots blower, and I hope it will be helpful to you. If you have any questions, please contact us. We will provide you with services http://www.rohs-international.com/